Print Print
Alliance iS HPLC Systems User Guide
Contents Contents
Alliance iS HPLC Systems User Guide
Download PDF Download PDF
Console features

Console Commands view

Console Commands view
Topic LCI-USG-0270, Last Updated 11/21/2025

From the Commands view, users can run the following system commands:

  • Flow control (see Flow control)
    Note: Starting with version 2.0, users can set parameters for flow rate and acceleration.
  • Reset the system
  • Emergency stop
  • Power the UV detector lamp on or off
  • Wash the needle (see Washing the needle)
    Note: Starting with version 2.0, users can set needle wash duration.
  • Autozero the detector (TUV detector only) (see Autozeroing the TUV detector signal)
    Note: If the lamp is off or the shutter is closed, the Autozero Detector command is disabled.

The following figure shows the Commands view.

Figure 1: Commands view (TUV)
Note: The figure shows the Commands view for a system with the TUV detector. The Commands view for systems with a PDA detector is similar.

Click the icon on the right-hand side of each command card to run the command. Click the left-hand side of the Flow Control or Wash Needle cards to adjust settings.

Need Help? Connect with a Waters expert. 

Create Support Request

To avoid risk of personal injury and to prevent damage to laboratory equipment, always operate your Waters products in accordance with the applicable operational and safety information, your organization’s standard operating procedures, and local regulations.

Refer to the English version of this page for the latest information.

Back To Top Back To Top